User Manual
Table Of Contents
- Notations Used in This Guide
- Introduction to Your Projector
- Setting Up the Projector
- Using Basic Projector Features
- Turning On the Projector
- Turning Off the Projector
- Displaying a Test Pattern
- Projection Modes
- Adjusting the Image Position Using Lens Shift
- Adjusting the Projector's Tilt
- Image Shape
- Resizing the Image with the Zoom Feature
- Focusing the Image with the Lens Button
- Selecting an Image Source
- Image Aspect Ratio
- Color Mode
- Adjusting the Image Quality
- Adjusting the Image Color
- Adjusting Projector Features
- Monitoring and Controlling the Projector
- Adjusting the Menu Settings
- Using the Projector's Menus
- Using the Displayed Keyboard
- Image Quality Settings - Image Menu
- Input Signal Settings - Signal I/O Menu
- Projector Installation Settings - Installation Menu
- Projector Display Settings - Display Menu
- Projector Feature Settings - Operation Menu
- Projector Administration Settings - Management Menu
- Projector Network Settings - Network Menu
- Image Quality Memory Settings - Memory Menu
- Projector Initial Settings and Reset Options - Initial/All Settings Menu
- Copying Menu Settings Between Projectors (Batch Setup)
- Maintaining the Projector
- Solving Problems
- Appendix
- Optional Accessories and Replacement Parts
- Screen Size and Projection Distance
- Supported Monitor Display Resolutions
- Projector Specifications
- External Dimensions
- List of Safety Symbols and Instructions
- Laser Safety Information
- Glossary
- Notices
- FCC Compliance Statement
- Indication of the manufacturer and the importer in accordance with requirements of EU directive
- Indication of the manufacturer and the importer in accordance with requirements of United Kingdom directive
- Restriction of Use
- Operating System References
- Trademarks
- Copyright Notice
- Copyright Attribution
Adjusting the Image Quality
50
e
Press the left or right arrow button to adjust the sharpness of image.
Higher values make the image sharper and lower values make the
image softer.
f
Press [Menu] or [Esc] to exit the menus.
Setting Frame Interpolation
You can use the projector's Frame Interpolation feature to smooth fast-
moving video by comparing consecutive image frames and inserting an
intermediate image frame between them.
Frame Interpolation is available in these conditions:
• Image Processing is set to Fine in the projector's Signal I/O menu.
• 4K 100/120Hz signals are not input.
a
Turn on the projector and switch to the image source you want to use.
b
Press the [Frame Int] button on the remote control.
c
Select the level of interpolation and press [Enter].
d
When you are finished, press the [Frame Int] button.
a
• If your resulting images contain noise, turn off the Frame
Interpolation setting.
• You can also set the Frame Interpolation setting in the projector's
Image menu.