User Manual
Table Of Contents
- Notations Used in This Guide
- Introduction to Your Projector
- Setting Up the Projector
- Using Basic Projector Features
- Turning On the Projector
- Turning Off the Projector
- Displaying a Test Pattern
- Projection Modes
- Adjusting the Image Position Using Lens Shift
- Adjusting the Projector's Tilt
- Image Shape
- Resizing the Image with the Zoom Feature
- Focusing the Image with the Lens Button
- Selecting an Image Source
- Image Aspect Ratio
- Color Mode
- Adjusting the Image Quality
- Adjusting the Image Color
- Adjusting Projector Features
- Monitoring and Controlling the Projector
- Adjusting the Menu Settings
- Using the Projector's Menus
- Using the Displayed Keyboard
- Image Quality Settings - Image Menu
- Input Signal Settings - Signal I/O Menu
- Projector Installation Settings - Installation Menu
- Projector Display Settings - Display Menu
- Projector Feature Settings - Operation Menu
- Projector Administration Settings - Management Menu
- Projector Network Settings - Network Menu
- Image Quality Memory Settings - Memory Menu
- Projector Initial Settings and Reset Options - Initial/All Settings Menu
- Copying Menu Settings Between Projectors (Batch Setup)
- Maintaining the Projector
- Solving Problems
- Appendix
- Optional Accessories and Replacement Parts
- Screen Size and Projection Distance
- Supported Monitor Display Resolutions
- Projector Specifications
- External Dimensions
- List of Safety Symbols and Instructions
- Laser Safety Information
- Glossary
- Notices
- FCC Compliance Statement
- Indication of the manufacturer and the importer in accordance with requirements of EU directive
- Indication of the manufacturer and the importer in accordance with requirements of United Kingdom directive
- Restriction of Use
- Operating System References
- Trademarks
- Copyright Notice
- Copyright Attribution
Image Shape
39
c
Select the Installation menu and press [Enter].
d
Select Geometry Correction and press [Enter].
You see the Geometry Correction screen.
e
Select Quick Corner and press [Enter]. Then select Yes and press
[Enter] if necessary.
You see the area selection screen.
f
Use the arrow buttons to select the area of the image you want to
adjust. Then press [Enter].
a
To reset the Quick Corner corrections, hold down [Esc] for
about 2 seconds while the area selection screen is displayed, and
then select Yes.
g
Press the arrow buttons to adjust the image shape as necessary.
To return to the area selection screen, press [Enter].