User Manual
Table Of Contents
- Notations Used in This Guide
- Introduction to Your Projector
- Setting Up the Projector
- Using Basic Projector Features
- Turning On the Projector
- Turning Off the Projector
- Displaying a Test Pattern
- Projection Modes
- Adjusting the Image Position Using Lens Shift
- Adjusting the Projector's Tilt
- Image Shape
- Resizing the Image with the Zoom Feature
- Focusing the Image with the Lens Button
- Selecting an Image Source
- Image Aspect Ratio
- Color Mode
- Adjusting the Image Quality
- Adjusting the Image Color
- Adjusting Projector Features
- Monitoring and Controlling the Projector
- Adjusting the Menu Settings
- Using the Projector's Menus
- Using the Displayed Keyboard
- Image Quality Settings - Image Menu
- Input Signal Settings - Signal I/O Menu
- Projector Installation Settings - Installation Menu
- Projector Display Settings - Display Menu
- Projector Feature Settings - Operation Menu
- Projector Administration Settings - Management Menu
- Projector Network Settings - Network Menu
- Image Quality Memory Settings - Memory Menu
- Projector Initial Settings and Reset Options - Initial/All Settings Menu
- Copying Menu Settings Between Projectors (Batch Setup)
- Maintaining the Projector
- Solving Problems
- Appendix
- Optional Accessories and Replacement Parts
- Screen Size and Projection Distance
- Supported Monitor Display Resolutions
- Projector Specifications
- External Dimensions
- List of Safety Symbols and Instructions
- Laser Safety Information
- Glossary
- Notices
- FCC Compliance Statement
- Indication of the manufacturer and the importer in accordance with requirements of EU directive
- Indication of the manufacturer and the importer in accordance with requirements of United Kingdom directive
- Restriction of Use
- Operating System References
- Trademarks
- Copyright Notice
- Copyright Attribution
Updating the Firmware
104
a
Do not disconnect the power cord from the projector while the
firmware is updating. If the power cord is disconnected, the
projector may not start correctly.
All of the projector's indicators turn on and the projector enters
firmware update mode. The computer recognizes the projector as a
removable disk.
f
On the computer, copy the firmware file to the root folder (highest
folder in the hierarchy) of the removable disk.
a
• Do not copy any other files or folders to the removable disk.
Otherwise, the files or folders may be lost.
• The projector turns off automatically if the USB cable or the
power cord are disconnected before the firmware file can be
copied to the removable disk. If this occurs, perform the
procedure again.
g
Perform the steps to safely remove a USB device from the computer
and disconnect the USB cable from the projector.
All of the projector's indicators start flashing and the firmware update
starts. When the update finishes normally, the projector enters standby
status (only the power indicator is lit blue). If Direct Power On is set to
On in the projector's Operation menu, the projector turns back on
again.
When the update finishes, check the Information menu in the projector's
Management menu to make sure that the Version information has been
updated to the correct firmware version.
a
• When all indicators flash rapidly, the firmware update may have
failed. Disconnect the power cord from the projector, and then
reconnect it to the projector. If the indicators continue to flash even
after reconnecting the power cord, remove the power plug from the
electrical outlet and contact Epson.
• If no operations are performed for 20 minutes in update mode, the
projector turns off automatically. If this occurs, perform the
procedure again.