User`s guide
Table Of Contents
- Notations Used in This Guide
- Contents
- Introduction
- Preparing the Projector
- Basic Usage
- Projecting Images
- Adjusting Projected Images
- Useful Functions
- Configuration Menu
- Troubleshooting
- Using the Help
- Problem Solving
- Reading the Indicators
- When the Indicators Provide No Help
- Problems Relating to Images
- No images appear
- Moving images are not displayed (only the moving image portion turns black)
- Projection stops automatically
- The message Not supported is displayed.
- The message No Signal is displayed.
- Images are fuzzy, out of focus, or distorted
- Interference or distortion appear in images
- The image is truncated (large) or small, or the aspect is not suitable
- Image colors are not right
- Images appear dark
- Problems when Projection Starts
- Other Problems
- Maintenance
- Appendix
- Index
Check Remedy
Is the correct setting for the remote receiver selected? Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver p.59
Other Problems
No sound can be heard or the sound is faint
Check Remedy
Check that the audio/video cable is securely attached to both the
projector and audio source.
(EB-X14G/EB-W02/EB-X02/EB-S02 only)
Disconnect the cable from the Audio port, and then reconnect the cable.
Is the volume adjusted to the minimum setting? Adjust the volume so that sound can be heard.
s Settings - Volume p.59
s "Adjusting the Volume" p.37
Is A/V Mute active? Press the [A/V Mute] button on the remote control to cancel A/V Mute.
s "Hiding the Image and Sound Temporarily (A/V Mute)" p.43
Is the audio cable's specification "No resistance"?
(EB-X14G/EB-W02/EB-X02/EB-S02 only)
When using a commercially available audio cable, make sure it is labeled "No resistance".
Is Output audio from the projector selected?
(Only when projecting USB Display)
Click All Programs - EPSON Projector - Epson USB Display - Epson USB Display Vx.xx Settings, and then select
Output audio from the projector.
The remote control does not work
Check Remedy
Is the remote control light-emitting area pointing towards the
remote receiver on the projector during operation?
Point the remote control towards the remote receiver.
s "Remote control operating range" p.17
Is the remote control too far from the projector? The operating range for the remote control is about 6 m.
s "Remote control operating range" p.17
Problem Solving
76