User`s guide

Check Remedy
Are connection denial functions, such as MAC Address
restrictions and port restrictions, set correctly at the access point?
Set the projector to allow connections from the access point.
Are the IP address, the subnet mask, and the gateway address for
the access point and the projector set correctly?
When not using a DHCP, adjust each setting.
Cannot connect the projector and the computer via the network
Check Remedy
Is the Network Configuration screen displayed on the projector? Close network settings on the projector, and return to the LAN standby screen. If the Network Configuration screen is
displayed on the projector, you cannot connect using EasyMP Multi PC Projection.
Is the firewall turned off, or has the firewall been registered as an
exception?
When you do not wish to turn off the firewall or register the firewall as an exception, make the necessary settings to
open the ports.
The ports used by EasyMP Multi PC Projection are "3620", "3621", and "3629".
Was the network adapter being used selected correctly with
EasyMP Multi PC Projection?
If the computer has multiple LAN environments, it cannot connect unless the network adapter is selected correctly.
When using a computer running Windows, start EasyMP Multi PC Projection, and select the network adapter you are
using from Switch LAN in Set options.
s "General Settings Tab" p.41
Are the access point and the projector's subnet different? Select Manual search from EasyMP Multi PC Projection, and then specify the IP address to connect.
s "Manual search" p.18
Does the projector support the EasyMP Multi PC Projection
version being used?
Install EasyMP Multi PC Projection from the EPSON Projector Software CD-ROM supplied with the projector.
Cannot select the projector
Check Remedy
Are you trying to combine a set of projectors that differs from a
combination created by a user who is already connected?
When another user is already connected, you can only connect to the projectors in the combination selected by the
other user. Select a projector from the same combination as the user who is already connected, or select a projector
that is in standby status.
Solving Problems
33