User`s guide

Troubleshooting
47
Cannot connect in Advanced Connection Mode or Wired LAN connection
The Slide Show cannot be displayed on the desired display when the multi-screen display function is being executed.
Applications are no longer displayed from the computer screen when the multi-screen display function is executed.
Check Remedy
Is the SSID setting different. Set the computer, the access point, and the projector to the same SSID. See your computer, router,
and projector manuals.
Is the same WEP key set? When selecting WEP from Security, set the access point, the computer, and the projector to the same
WEP key. See your computer, router, and projector manuals.
Are the connection denial functions, such as MAC
Addressg restrictions and port restrictions, set correctly at
the access point?
Set the projector to allow connections from the access point.
Are the IP address, the Subnet Mask, and the Gateway
Address for the access point and the projector set
correctly?
When not using a DHCP, adjust each setting. See your projector User’s Guide.
Are the access point and the projector's subnet different? Select Manual search from EasyMP Network Projection, specify the IP address, and connect.
s p.32
Check Remedy
Are you using PowerPoint 2002 or an earlier version?
For Windows
To set up and use two or more virtual displays
g, use PowerPoint 2003 or later, or limit the number of
virtual displays to one before displaying the Slide Show.
Check Remedy
Is another application running on the virtual display
g?
For Windows
When EPSON Virtual Display is installed, another application sometimes runs on the virtual display. In
this case, set EPSON Virtual Display to "Off" in "Screen properties".