Setup guide

39
EasyMP.net Operation Guide
Integrated Management for Projector Status Check and Control (EMP Monitor)
EMP Monitor allows you to check the status of multiple projectors on the
network, switch them on or off, and switch between video sources
simultaneously. Up to 64 projectors can be monitored and controlled
simultaneously.
System Configuration Example
Read the following notes before installing the EMP Monitor software.
• The EMP Monitor software must be installed on the network PC.
"EasyMP.net Software" in the EasyMP.net Setup Guide.
• The PC and projectors must be ready to be connected to the network.
• Only the administrator can start a PC running Windows 2000/NT4.0/XP
OS.
Registering Projectors to be Monitored
Use this procedure when you start EMP Monitor for the first time after
installation or when you register an additional projector. Once you have
registered the projector, the status of registered projectors will be displayed
automatically each time you start EMP Monitor.
PROCEDURE
Select "Start" - "Program" (or "All Programs") -
"EPSON Projector" - "EMP Monitor" in this order to
start EMP Monitor.
Click "Register projector".
Preparing the PC
EMP Monitor
This projector A
PC
This projector
B
This projector C
Turn ON
Turn
projector B
ON
TIP
You can monitor projectors even when they are in standby mode
(when the indicator light is lit orange ), but only if you have selected
"Advanced1" and "Standby Mode" from the projector's
configuration menu and if you have selected the " " option.
1
2
Click to add a projector to
be monitored.