Setup guide

40
Hints on How to
Integrated Projector Management
EMP Monitor allows you to turn the power on or off for multiple projectors through
the network. You can also monitor the projectors by listing their status.
"Integrated Management for Projector Status Check and Control (EMP
Monitor)" in the EasyMP.net Operation Guide
The Mail Notification function automatically sends an e-mail to the preset address
and reports an abnormal status when it occurs. A projector problem can be detected
from a remote location.
Setting the Mail Notification Function
The mail destinations and events to be reported can be set in any of the following
software.
Turning Multiple Projectors On or Off
Reporting an Error by Mail Notification
• Up to three mail destinations can be set and an e-mail message can
be sent to these destinations simultaneously.
• If the projector has failed to start up suddenly due to a fatal error
occurring in the projector, the mail may not be sent.
• If you have selected the "Advanced1" and set the "Standby Mode" to
"Network ON" in the configuration menu of the projector, you can
monitor the projector even when it is in the standby status (when the
indicator is lit orange).
• EasyConfiguration Select "Network" and "Mail Notification
function". "Establishing the Mail
Notification Function" of "Network
Setup(LAN Setup)" in the EasyMP.net
Operation Guide
• EasyWeb Select "EasyConfiguration", "Network" and
"Mail Notification function".
"Projector
Setup from the PC (EasyWeb)" in the
EasyMP.net Operation Guide