User`s guide

Check Remedy
Is the Mic Input Level set at the maximum? Lower the Mic Input Level.
s Settings - Mic Input Level p.131
Is A/V Mute active? Press the [A/V Mute] button on the remote control to cancel A/V Mute.
s "Hiding the Image and Sound Temporarily (A/V Mute)" p.102
Is the audio cable's specification "No resistance"? When using a commercially available audio cable, make sure it is labeled "No resistance".
Is it connected with an HDMI cable? If no audio is output when connecting via an HDMI cable, set the connected equipment to PCM output.
Is Output audio from the projector selected?
(Only when projecting USB Display)
Click All Programs - EPSON Projector - Epson USB Display - Epson USB Display Ver.x.xx Settings, and then select
the Output audio from the projector checkbox.
Is the correct audio input selected? Check the Audio Output, HDMI1 Audio Output, and HDMI2 Audio Output settings from the Configuration menu.
s Extended - A/V Settings p.132
No Sound Can Be Heard from the Microphone
Check Remedy
Is the microphone connected correctly? Disconnect the cable from the Microphone (Mic) port, and then reconnect the cable.
s "Connecting a Microphone" p.37
Is the microphone input volume turned down too low? Adjust the microphone input volume so that sound can be heard.
s Settings - Mic Input Level p.131
Are you using a plug-in power type microphone? The projector does not support plug-in power type microphones. Use a commercially available dynamic microphone.
s Settings - Mic Input Level p.131
There Is Noise in the Audio (only when Projecting USB Display)
Check Remedy
Is the volume for the computer set to minimum while the projector's
volume is set to maximum?
The audio may contain noise if the volume for the computer is set to minimum while the projector's volume is set to
maximum. Increase the volume for the computer, and decrease the volume for the projector.
s Settings - Volume p.131
Problem Solving
166