User`s guide

Error message when starting up EasyMP Network Projection
Error Messages Remedy
Connection to the projector failed. Try connecting again. If you still cannot connect to the projector, check the network settings on the computer and the
network settings for the projector.
You can make network settings from the projector's Network menu.
See the following manual for details.
s User's Guide
XXXXXX was disconnected.
The keyword does not match. Re-enter the keyword displayed on
the projector screen.
Check the Projector Keyword displayed on the LAN standby screen, and enter the Projector Keyword.
The selected projector is busy. Do you want to continue the
connection process?
You tried to connect to a projector that is connected to another computer.
When Yes is clicked, a connection to the projector is established. The connection between the projector and the other
computer is cut off.
When No is clicked, a connection to the projector is not established. The connection between the projector and the
other computer is maintained.
EasyMP Network Projection initialization failed. Restart EasyMP Network Projection. If the message still appears, uninstall and then reinstall EasyMP Network
Projection.
s "Installing" p.7
Connection failed due to keyword mismatch. When connecting to a projector for which a Projector Keyword has been set, the wrong Projector Keyword is entered.
Check the Projector Keyword that is displayed on the LAN standby screen.
s
"Operating the Computer" p.11
Network adapter information could not be obtained. Check the following point.
• Is a network adapter installed on the computer?
• Is the driver for the network adapter used installed on the computer?
• Is the network adapter enabled?
After checking, restart the computer and connect again.
If you still cannot connect, check the following.
Check the network settings on the computer and the network settings on the projector.
You can make network settings from the projector's Network menu.
See the following manual for details.
s User's Guide
One or more connected projectors do not support resolutions
greater than SXGA. Reduce the screen resolution and reconnect.
There is an ELP-735 projector in the connection destination. Change the computer screen resolution to SXGA
(1280x1024) or less.
Troubleshooting
47