User`s guide

Check Remedy
Are the access point and the projector's subnet different?
(For Advanced Connection Mode)
Select Manual search from EasyMP Network Projection, specify the IP address, and connect.
s "Specifying Either an IP Address or Projector Name and Performing a Search (Advanced Connection Mode
Only)" p.17
Have you enabled DHCP?
(For Advanced Connection Mode)
When DHCP is set to On in Advanced Connection Mode, it may take some time to enter LAN standby status if an
available DHCP server is not found.
When a connection is made using EasyMP Network Projection, the projected image remains as it is, and a connection cannot be made
from another computer.
Check Remedy
Did the presenter leave the conference room without cutting off the
network connection?
With EasyMP Network Projection, the computer currently connected can be disconnected when another computer
tries to connect to the projector.
Therefore, when a Projector Keyword is not set for the projector, or if you know the Projector Keyword, you can
disconnect the computer currently connected and then connect your computer to the projector.
When a Projector Keyword is set for the projector and you do not know the Projector Keyword, restart the projector
and reconnect.
Cannot select or change the connection mode.
Check Remedy
Is EasyMP Network Projection set to start up using the same
connection mode?
Select Display Connection Mode Selection window on startup on the General settings tab from Set options. The
projector selection screen is displayed after restarting EasyMP Network Projection.
The screen is not projected.
The Slide Show cannot be displayed on the desired display when the multi-screen display function is being executed.
Check Remedy
Are you using PowerPoint 2002 or an earlier version?
(For Windows)
To set and use two or more
virtual displays g , use PowerPoint 2003 or later, or limit the number of virtual displays to
one before displaying the Slide Show.
Troubleshooting
44