User`s guide

Cannot connect the projector and the computer via wired LAN.
Check Remedy
Are the computer's LAN card and the built-in LAN function
available?
Check that LAN is available from the device manager under Control Panel - System - Hardware.
Is the network cable connected correctly? Check that the network cable is connected correctly. Reconnect it if it is not connected or not connected properly.
Cannot connect the projector and the computer via the network.
Check Remedy
Is the network configuration screen displayed on the projector? Close network settings on the projector, and return to the LAN standby screen. If the network configuration screen is
displayed on the projector, you cannot connect using EasyMP Network Projection.
Was the network adapter used selected correctly with EasyMP
Network Projection?
If the computer has multiple LAN environments, it cannot connect unless the network adapter is selected correctly.
When using a computer running Windows, start EasyMP Network Projection and select the network adapter you are
using from Set options - Switch LAN.
s "General settings tab" p.35
Is the firewall turned off, or has the firewall been registered as an
exception?
When you do not wish to turn off the firewall or register the firewall as an exception, make the necessary settings to
open the ports.
The ports used by EasyMP Network Projection are "3620", "3621", and "3629".
Is the SSID setting different?
(For Advanced Connection Mode)
Set the computer, the access point, and the projector to the same SSID.
You can make the SSID setting from the projector's Network menu.
See the following manual for details.
s
User's Guide
Are the connection denial functions, such as
MAC Address g
restrictions and port restrictions, set correctly at the access point?
(For Advanced Connection Mode)
Set connection permission at the access point to allow projectors to connect.
Are the IP address, the subnet mask, and the gateway address for
the access point and the projector set correctly?
(For Advanced Connection Mode)
When not using a DHCP, adjust each setting.
You can make the DHCP setting from the projector's Network menu.
See the following manual for details.
s User's Guide
Troubleshooting
43