User`s guide

a
Click Start, select Programs (or All Programs), EPSON Projector,
EasyMP Network Projection, and then click Add-Remove Virtual
Display.
The Add-Remove Virtual Display screen is displayed.
b
Select the virtual display you want to use.
Up to four monitors can be added. In this example, a single virtual
display is to be used. When setting multiple virtual displays, select as
many displays as necessary.
Any one of the displays can be selected.
c
Click OK.
When you click OK, the drivers for the virtual display are enabled.
At this point, it is normal for the display to flicker. Wait for the
Add-Remove Virtual Display screen to close.
Adjusting the Virtual Display
After starting EasyMP Network Projection, the procedure for setting up the
virtual displays differs for Windows and Mac OS X. The procedures are
explained separately below.
a
Check the following points before starting EasyMP Network Projection
when connecting via Wireless LAN. If the following points are not set
correctly, Multi-screen display cannot be used.
• The SSID for the computer and each projector must be the same.
(For Quick Connection Mode)
• The wireless LAN system for the computer and each projector must
be the same.
You can modify the SSID and wireless LAN system for the projector
from the projector's Network menu.
See the following manual for details.
s User's Guide
For Windows
a
Click Start, select Programs (or All Programs), EPSON Projector,
EasyMP Network Projection, and then click EasyMP Network
Projection V2.XX to start EasyMP Network Projection.
b
Select Quick Connection Mode or Advanced Connection Mode,
and then click OK.
c
Select the Use multi-display check box.
Using Multi-Screen Display
28