Specifications

Confidential

EPSON

TITLE

SHEET

REVISION

NO.

SHEET

DM-D110

Specification

(STANDARD)

52 51

US v n

[Name] Status confirmation by DTR signal

[Format] ASCII US v n

Hex 1F 76 n

Decimal 31 118 n

[Range] n = 0, 1, 48, 49

[Description] Sets the DTR signal in the host interface to the MARK or SPACE state.

[Notes] • When n = 1 or n = 49, the DTR signal goes to the MARK state.

If it is already in the MARK state, the DTR signal does not change.

• When n =0 or n = 48, the DTR signal goes to the SPACE state if the following

conditions are satisfied:

➀ The receive buffer is not in the buffer-full state.

➁ The self-test is not being executed.

If it is already SPACE when n = 0 is received, the DTR signal does not change.

• This command is effective only when the display alone is selected by

ESC = 2

Therefore, if the printer is already selected, this command (three bytes) is ignored and

is processed as normal data. (The data is transmitted to the printer.)

• If any data is received during status confirmation using the DTR signal, normal

interface timing control is executed immediately.

US @

[Name] Execute self-test

[Format] ASCII US @

Hex 1F 40

Decimal 31 64

[Description] Executes the self-test.

[Notes] • A series of self-tests is displayed. All set values except those listed below are

initialized:

1) User-defined character definitions

2) Macro definitions

3) Time counter value

• After completion of the self-tests, the screen is cleared and the display position is

moved to the home position.

[Reference] Section 4.4, Self-test