User`s guide
Table Of Contents
- Chapter 1: Getting Started
- Chapter 2: Taking Photos
- Chapter 3: Adjusting the Camera Settings
- Chapter 4: Reviewing Photos
- Chapter 5: Sharing and Printing Photos
- Chapter 6: CompactFlash Memory Card
- Chapter 7: Powering Your Camera
- Chapter 8: Care, Maintenance and Safety
- Chapter 9: Troubleshooting and Assistance
- Appendix A: Reference
- Appendix B: Regulatory and Warranty Information
- Index
www.hp.com/photosmart 53
When I press the
Shutter button half
way down, a
green blinking
light appears next
to the viewfinder.
The flash is turned off
and there is not
enough light.
Use the flash.
The date and/or
time is wrong.
The batteries were
dead or removed from
the camera for more
than five minutes.
Reset the date and time. To avoid losing date and time
information, replace low batteries promptly.
When I connect the
camera to my
computer, the
software says it
can’t find the
camera.
The camera is not
connected to the
computer properly.
Make sure the USB cable is firmly connected at both
ends and the cable is connected directly to a working
USB port. The connection may not work if connected to
a USB hub.
The camera is turned
off.
Slide the mode switch down to the playback icon to
turn the camera on.
The batteries are low. Replace the batteries or use an AC power adapter.
A conflicting software
application may be
open.
Exit from all programs while you are using the ArcSoft
PhotoImpression software.
Problem Possible Cause Solution