Specifications

-227
Service Req Exxx (Cxxxx)
A controller error or a print engine error has been detected. Write
down the error number listed on the LCD panel and turn off the
printer. Wait at least five seconds and then turn it back on. If this
error still occurs, turn off the printer, unplug the power cord, and
contact a qualified service representative.
Standby
The printer is in its low power state; however, it is still online if
the On Line light is on.
Toner Low
The printer is almost out of toner. You should prepare a new
imaging cartridge for replacement.
Toner Out
You must replace the Imaging Cartridge. See “Replacing the
Imaging Cartridge”. This message is not displayed when Toner
Out is set to Continue in SelecType.
Press Continue to print one more page.
Warming Up
The printer is warming up. When the printer is ready, this
message will change to Ready.
Write Error ROM A
A write error has occurred on the ROM module in slot A. Replace
themodulewithanewone.