Specifications

-130
Using the Control Panel
Pen
Selects the logical “pen” which is used to “plot” the drawing.
End
Selects the way in which lines end.
Join
Selects the way in which lines are joined.
Pen0 through Pen6
Selectsthethicknessoftheseven“pens” used to make the
printout.
Differences between the two emulations
The table below shows the differences between
Hewlett-Packard’sandEPSON’s emulation of the GL/2 mode.
Command HP GL/2 mode EPSON GL/2 mode
Orientation Printer setting Landscape only
Plotterunit 1/1016inch 1/1021inch
Picture frame Same as LaserJet 4
mode
Depends on the
hard-clip limit
Default position
of P1 and P2
Lower left and lower
right corners,
respectively, of
picture frame
Inside of picture frame
Undefined
commands
First character is
ignored
First two characters
are ignored
CS, CA
commands
Not supported Partially supported
PG, AF
commands
Not supported Supported