Specifications

l FDD
Your system provides an on board FDC and it supports two
floppy disk drive to your system. If you use another FDC in
your system using an expansion Card, you should disable this
option.
Leaving the Setup Program
When you have completed the changes, press the < ESC >
key. The SETUP
program will display the message:
If you have made any mistakes, press N for No, then move the
cursor back up to the beginning and verify each parameter,
making any corrections necessary. When you are satisfied with
the option settings, press the < ESC > key, then press Y to
write the new settings into the configuration RAM. Your
computer will run through the self test diagnostics again and
try to read a diskette in the first floppy disk drive.
As mentioned above, you may see an error message if you don’t
have a system diskette inserted into the floppy disk drive.
2-10 The CMOS Setup Program