Specifications

Hardware Settings
This system provides the programs to set the system
configuration. The program “EISA Configuration Utility” can
be used whenever you change the system hardware settings.
If you want to do the followings, run the “EISA Configuration
Utility” program and change the configuration settings.
l Install the EISA board on your system
l Change the memory configuration
l Set the 82485 cache controller to select optional cache
memory size
l Select the video monitor type
l Select the CPU speed of EISA bus controller.
When you turn the system power on, the system CPU will
compare these settings with the information stored in its
configuration RAM as part of the diagnostic routines. If any
inconsistencies are found, they will be shown on the display
monitor before MS-DOS is loaded. At that time, you will be
prompted to run the SETUP program or to run the “EISA
Configuration Utility” program (See the following message) to
change the options stored in the configuration RAM.
B-2 System Mother Board