Service manual

EPSON Color Copy Station 8200 Revision A
Disassembly and Assembly BIOS Re-Setting 52
4.4.3 BIOS Re-Setting
1. Remove the mother board. (Remove SCSI, ISA and PCI boards and
connect the power supply unit)
2. Install the video card (EGA/VGA) to the open slot.
3. Connect the corresponding CRT to the video card.
4. Connect the keyboard to the keyboard connector on the mother
board. (Connector of the keyboard is DIN 5-pin AT type)
5. Turn on the power. When BIOS boots, press
DEL
key on the key
board and enter the Set-up screen of BIOS.
6. Select “STANDARD CMOS SETUP”.
7. Check the BIOS setting value by referring the following table.
8. Input “Date” and “Time” and press
ESC
key.
9. Select “SAVE&EXIT SETUP”, and change “N” to “Y” and press
Enter
key.
10. Turn the power OFF and remove the video card and key board, and
install the mother board to the CCS 8200 body.
BIOS re-setting is completed and it will operate normally when the
power is turned on next time.
Table 4-5. SP97 Mother Board BIOS Setting Value
Setting Item Setting Value
STANDARD CMOS SETUP
Date :mm:dd:yy (Setting Date)
Time :hh:mm:ss (Setting Time)
HARD DISKS
Primary Master Auto
Primary Slave Auto
à
None
Secondary Master Auto
à
None
Secondary Slave Auto
à
None
Drive A 1.44M 3.5in
Drive B None
Floppy 3 Mode Support Disabled
Video EGA/VGA
Halt On All, But Disk/Key
BIOS FEATURE SETUP
Boot Virus Detection Disabled
CPU Internal Cache Enabled
External Cache Enabled
Quick Power On Self Test Enabled
HDD Sequence SCSI/IDE First IDE
Boot Sequence A,C
Boot Up Floppy Seek Disabled
Floppy Disk Access Control R/W
IDE HDD Block Mode Sectors HDD MAX
HDD S.M.A.R.T Capability Disabled
PS/2 Mouse Function Control Auto
OS/2 Onboard Memory > 64M Disabled
PCI/VGA Pallete Snoop Disabled
Video BIOS Shadow Enabled
Table 4-5. SP97 Mother Board BIOS Setting Value
Setting Item Setting Value