Service manual

EPSON Color Copy Station 8200 Revision A
Disassembly and Assembly Disassembly and Assembly 49
4.2.5 Panel Board Removal
1. Remove the harness (control panel cable) from the CCS 8200.
2. Remove 8 CPB screws (3x12) securing the upper panel case and lower
panel case. Then remove the lower panel case.
Figure 4-5. Screws for Lower Panel Case
3. Remove 2 plain washers and 2 CPB screws (2x5) securing the panel board
to the upper panel case. Then remove the panel board.
Figure 4-6. Screws securing the Panel Board
n
When installing the panel board to the upper panel case, make sure
that intensity adjustment volume moves.
n When installing the panel board to the upper panel case, tilt the lead
part of LED so that the LED on the board comes into the LED lens of
the upper panel case. (See the figure below)
CAUTION
When tightening screws, use a hand in order to avoid
loosen screws. Do not use motor driver.
n When installing the panel board to the upper panel case,
electrolytic condensers on the board may touch the
upper panel case. Tilt the condenser as it is shown in
the figure below so that they do not touch the upper
panel case. (See the figure below)
Upper Panel Case
Panel Board
LED
Panel
Board
CPB (3x8)
CPB (3x8)
Upper Panel Case
Lower Panel Case
Upper Panel Case
Panel Board
UPB (2x5), plain washer
Electrolytic Condenser