Service manual

EPSON Color Copy Station 8200 Revision A
Disassembly and Assembly Disassembly and Assembly 47
NOTE:
Leave SLOT2 available for installing ISA Master Board.
4.2.2.2 SCSI Board Removal
1. Remove the upper case. (See “Upper Case Removal” on page 46)
2. Remove one screw (SMH/W6#X6N) securing SCSI board to the body
case.
3. Remove SCSI board from the slot (PCI2) of the mother board. (See “ISA
Board Removal” on page 46)
4. Install the SCSI board to the appointed slot to stabilize operation.
NOTE:
Install SCSI Board to the specified slot for stable movement.
NOTE:
Screw tightening tongue: 11 ± 0.5kgf.cm
4.2.2.3 Network Board Removal
1. Remove the upper case. (See “Upper Case Removal” on page 46)
2. Remove one screw (SMH/W6#X6N) securing the Network board to the
body case.
3. Remove Network board from the slot (PCI3) of the mother board. (See
“ISA Board Removal” on page 46)
NOTE:
Screw tightening tongue: 11 ± 0.5kgf.cm
4.2.2.4 ECP Board Removal
1. Remove the upper case. (See “Upper Case Removal” on page 46)
2. Remove one screw (SMH/W6#X6N) securing the ECP board to the body
case.
3. Remove ECP board from the slot (PCI1) of the mother board. (See “ISA
Board Removal” on page 46)
NOTE:
Screw tightening tongue: 11 ± 0.5kgf.cm
Table 4-2. PCI/ISA Slot, installing board
Slot Type Installing Board
PCI1 PCI ECP Board (for printer interface)
PCI2 PCI SCSI Board (for scanner interface)
PCI3 PCI Network Board
PCI4/SLOT1 PCI/ISA ISA Board
SLOT2 ISA Blank (for installing ISA Master Board)