System information

__________________________________________________
Blastware Compliance Module
Blastware Operator Manual 4–63
You may set the Date and Time in your monitor in two ways. The first method is to copy the
settings from your PC, as displayed in the PC Date/Time area. Make sure the date and time are
correct, and then click on the Send to Unit button. The date and time in the Unit Date/Time area
will change to match the PC Date/Time. You can also set the date and time manually: enter the
current date and time in the Unit Date/Time area then send the changes to the unit by clicking on
the Set Date/Time button.
b. Adjust Speed (Series II, Series III and Minimate Blaster Only)
The Adjust Speed button is used to adjust the units clock if it is running too fast or too slow. The
Set Clock Speed dialog box appears:
Select the appropriate radio button and enter the number of seconds in a 24-hour period that the
clock is slow or fast. Use the Increase and Decrease buttons to change the number of seconds.
Click OK to send the time correction to the unit and close the dialog box.
Note: The Self Check function must be activated for the unit in order for the time to be
corrected. The time is adjusted as part of the Self Check. The Daily Self check is
scheduled in hours and minutes and occurs at 30 seconds into the chosen minute. The
amount of the correction is limited to 28 seconds so that the minute does not change.
Example: 11:59:30 + 28 sec = 11:59:58 or 11:59:30 - 28 sec = 11:59:02
Note: This feature is not required for Series IV units.
c. Micromate
Open the Unit Menu and select Date/Time. The Set Unit Date/Time dialog box appears.