System information

Blastware Compliance Module
___________________________________________________
4–62 Blastware Operator Manual
b. Perform Test
This runs Sensor Check and tests the sensors connected to the monitor. Click on the Perform Test
button.
c. Plot Waveform
This displays a graphic representation of the Sensor Check results. Move the cursor to the channel
results you wish to see and press the Plot Waveform button. The plot appears on your computer
display.
d. Fetch Results
This command obtains the most recent Sensor Check results stored in the monitor. Click on the
Fetch Results button.
e. Channel 1, 2, 3, 4, 5, 6, 7, and 8
You have a choice of which channels will be tested by Sensor Check. Click on the checkbox to
display a checkmark for each channel to be tested. To exclude channels from the Sensor Check,
click on the checkbox to remove the selection. Sensor Check results for excluded channels are
indicated by the word None in the Test Type column. Rows of dotted lines (---------) fill each of
the other columns. For eight channel monitors, channels 5, 6, 7, and 8 will also be displayed.
f. Most Recent Test Results
This displays the Sensor Check test results for each channel tested. The results for the Linear “L”
and the “A” Weight microphones differ. The Linear “L” results appear with a Test Type called
Square Wave and are similar to the dialog box above. Series IV supports the Linear Microphone.
4.2.6 Date/Time
a. Blastmate III, Minimate Plus or Series IV
Open the Unit Menu and choose Date/Time. The Set Unit Date/Time dialog box appears.