System information

Blastware Compliance Module
___________________________________________________
4–38 Blastware Operator Manual
(1) Automatically Print Event After Recording
Choose this to print the Event Summary Report immediately after recording an Event. To turn this
on, position the mouse pointer on the checkbox and click the mouse button to display a
checkmark.
(2) Copies
Multiple copies of the Event Summary Report can be printed automatically. The number of copies
ranges from one to ten. Click on the Copies text box and enter a new number.
(3) Print Recording Setup
This prints the recording setup used by the monitor to record the Event. The setup information
specifies the trigger source, trigger level, record time, sampling rate, and notes. Position the mouse
pointer on the Print Recording Setup checkbox and click to display a checkmark.
(4) Print Waveform
This prints a graphical waveform representing the Events activity recorded by each channel. To
include this, click on the Print Waveform checkbox.
(5) Print Compliance Report
Use this command to print the Compliance Report, also known as a National Frequency Standard,
on each Event Summary Report. To include the compliance report, click on the Print Compliance
Report checkbox to display a checkmark.
(6) Sensor Check
This prints a graphical representation of the Sensor Check results for each Geophone and the
microphone channel. The Pass/Fail status of the Sensor Check always appears on the Event
Report, but the numerical results are only included when the graph is present. You can choose to
include the Sensor Check graph in the Event Summary Report or not. Click on the checkbox to
display a checkmark and include the Sensor Check graph.