System information

__________________________________________________

Blastware Compliance Module

Blastware Operator Manual 4–17

11. Within Blastware, select the Unit > Communications menu. The

Communications Setup dialog appears. Select the Series IV Ethernet option.

12. Select Static IP Address for Series IV monitors. Static IP Address is only

available if a Series III unit is selected.

13. Select the Test button within Communications Setup to ensure that the

communications link has been established. The following dialog will appear:

Select the unit that you have attached (if a router is being used, and you have more

than one unit attached, all of the units will appear in the TCP/IP Discovery

window), identified by the Serial Number, and click on the Test button. With a

successful communication link, you will receive the message below:

Click on OK and then Exit to return to the Communication Setup dialog. Press

Close to exit to the Blastware Event Manager.

14. If you receive a message, Timeout on waiting for Response from the Unit!

ensure that Windows has completed negotiating the communications protocol and try the

Test button again. The negotiation progress can be viewed in the Windows Taskbar:

15. If you are still experiencing difficulty in establishing a successful communication link,

ensure that the Windows TCP/IP setup is correct. Double click on the icon that

epresents your Series IV connection in the Taskbar, as shown above. The following

dialog will appear: