System information

Blastware Advanced Module
____________________________________________________
6–68 Blastware Operator Manual
Determine the values for the Timeline Generation, select the Sorting Options, and create a
Project Directory.
(2) Process the Simulation
Once you have selected Process, a brief message appears stating that the following two
subdirectories were created in the designated Project Directory (in this instance,
C:\Blastware\Design) that you create using the “…”.
These directories will store the generated timeline and waveform files that will be created based
on the input values. The top level folder, in this example, /DESIGN, is where the Signature Hole
Analysis Table is stored. An ASCII delimited file used to create the Signature Hole Analysis
Table for each project will be placed directly in the Project Directory folder.
1. Signature Hole Analysis Simulation than begins Generating Timeline Files, as shown
below:
2. After creating the necessary Timeline Files, the tool will begin Generating Simulated
Event Files, as shown below:
The number of Simulated Event Files that are created, and the subsequent amount of
time it takes to create these files, is in direct proportion to the values that are input under
the Timeline Generation section.
3. Next, the Signature Hole Analysis Simulation tool begins Generating Data Table: