System information

____________________________________________________
Blastware Advanced Module
Blastware Operator Manual 6–61
To enter notes or a header, click on the appropriate text box and type in the desired contents,
to a maximum of 40 characters. Click on OK to save your notes. Click Cancel (Esc) to close
the Edit notes dialog box without adding notes.
6.11.2 Linear Superposition
This feature will linearly shift and superimpose a source waveform event according to the arrival
times present in a timeline file. A synthetic waveform is produced.
WARNING: This is a modeling tool only. Actual results will vary depending upon site
particularities including geology, and explosives type, among other factors.
a. Use 3 channels
To use three waveforms in your calculation, click on this checkbox to display a checkmark.
b. Source Waveform
Choose the waveform to be used in the analysis.
c. Display result in
Choose a waveform window to display the analysis result in. You can replace the source
waveform with the resulting waveform.
d. Name result
Enter a name for the new waveform. By default, Blastware names the Linear Superposition
Analysis waveforms beginning with SSM1. The number changes incrementally for additional
waveforms.
e. Timeline Handling
(1) Load New File
You must choose and load a timeline file before calculating the Linear Superposition Analysis
waveform. The timelines represent the number of shots and the delays.
(2) Edit/Create
Refer to section 5.9.7 for more information about the Edit Timeline feature.
f. Command Buttons
(1) Process
Click on this command to generate the Linear Superposition Analysis waveform.