System information

____________________________________________________
Blastware Advanced Module
Blastware Operator Manual 6–17
6.5 Flex™ Setup (Series III only)
Flex Setup is a feature for Series III monitors providing pre-defined setups for channels to operate
with a combination of standard sensors and alternative sensors such as accelerometers, crack
extensometers, temperature sensors, or humidity sensors.
Each set of four channels can be setup with one of the following predefined channel combinations:
Flex Setup can be accessed by either clicking on the Flex Setup icon in the Blastware Main Menu
Icon Toolbar, or by clicking on Unit, Setup, Flex Setup.
To configure the monitor, select the appropriate settings within the Flex Setup tabbed dialogs of
Recording Setup, Notes, Special Setups, and Library Files. After you have chosen the required
settings, select Send To Unit to send the settings to the monitor. If you do not wish to accept the
changes, or send them to your unit, then select Cancel.
a. Recording Setup
(1) Set Channels 1-4 (5-8)
Use the Set Channels drop down menus to select a predefined flex configuration. Click on Set to
apply the channel settings to the 4 channels listed below the Set Channels dropdown menu.
(2) Channels
Configure the monitors channels using the following settings. These items can only be changed
using the Blastware software (advanced module).