User`s manual

Contents

1. FEATURES......................................................................................................................1

2. GENERAL SPECIFICATION...................................................................................2

3 UNPACKING AND CHECKING THE PARTS.....................................................3

3.1 VFD POLE DISPLAY FOR 720/750 M ONITOR ..........................................3

3..4. POLE DISPLAY FOR 800cx SERIES.......................................................................6

3. 5 STAND ALONE VFD POLE DISPLAY ........................................................................7

4. INTERFACE...................................................................................................................8

4.1. VFD POLE DISPLAY FOR 720/750 M ONITOR.................................................8

4.4. VFD POLE DISPLAY FOR 800cx SERIES ............................................................14

4. 5 STAND ALONE VFD POLE DISPLAY ......................................................................15

4.5.1. Specifications...................................................................................................15

4.5.2. The communication flow................................................................................15

4.5.3. Interface ...........................................................................................................16

5. DIP SWITCH AND SOFTWARE SETTING......................................................18

5.1 COMMAND TYPE SELECTION....................................................................................18

5.2 BAUD RATE SELECTION.............................................................................................18

5.3 PARITY CHECK SELECTION........................................................................................18

5.4 DEMO MODE SELECTION..........................................................................................18

5.4 INTERNATIONAL CHARACTER SET ...........................................................................19

5.5 SELF-TEST ...................................................................................................................19

5.6. SOFTWARE STATUS SETTING...................................................................................20

5.6.1. Baud rate..........................................................................................................20

5.6.2 International character set.............................................................................20

5.6.3 Command type select.......................................................................................21

5.6.4 Reset EEPROM ................................................................................................21

5.6.5 Save data for demo display............................................................................22

5.6.6 Run Demo message..........................................................................................22

5.6.7 Set Communication parity..............................................................................23

5.6.8 Show VFD Firmware Version........................................................................23

5.6.9 Save title data to EEPROM ............................................................................23

6. COMMAND LIST TABLE.......................................................................................24