Service manual

EPSON Stylus Pro 10000/10000CF Revision B
Troubleshooting
T
roubleshooting Using the Messages 97
Table 3-19. Replace ink cartridge
Item Description
LCD message INK COMPART. OPEN
LED indicator
status
N/A
Explanation Ink holder is open.
Recovery
Close the holder cover.
• If it occurs in "PRINTING" or "READY" status, it return to
"READY" status.
• If it occurs in "PAUSE" status, it returns to "PAUSE" status.
Table 3-20. Ink end
Item Description
LCD message INK OUT
LED indicator
status
Corresponded "INK OUT" LED goes on.
Explanation
Ink end error occurs when ink cartridge and sub tank reached ink end
level.
Recovery Set new ink cartridge.
Table 3-21. No ink cartridge
Item Description
LCD message NO INK CARTRIDGE
LED indicator status Corresponded "INK OUT" LED goes on.
Explanation The ink cartridge is not set completely in the cartridge holder.
Recovery Set ink cartridge completely.
Table 3-22. Type-B interface error
Item Description
LCD message OPTIONAL I/F ERROR
LED indicator status N/A
Explanation
An unsupported optional interface card is installed but cannot be
used.
Recovery
Turn off the printer, remove the unsupported option card, and
turn the printer back on. Install a supported option card if
necessary.
Table 3-23. Cannot test print
Item Description
LCD message Cannot Print
LED indicator status Same as before this error arose.
Explanation
Cannot perform test print.
Due to one or more of the following reasons the printer cannot
print a nozzle check pattern, status sheet, PG adjustment pattern,
or paper thickness pattern:
1) No paper loaded
2) Ink cartridge missing
3) Paper recognition error
This error appears on the LCD panel for about three seconds, and
then the display returns to its previous state.
Recovery
Exit SelecType mode and clear the error that appears on the
LCD panel. Then return to SelecType mode and print.