Service manual

EPSON Stylus Pro 10000/10000CF Revision B
Troubleshooting
T
roubleshooting Using the Messages 95
Table 3-10. Different paper source is selected on panel
Item Description
LCD message LOAD xxxx PAPER
LED indicator
status
• "PAPER OUT" LED goes on.
• The LED blinks corresponding to paper path set with PP command of
remote command as following table;
Explanation
Roll paper and cut sheet size settings differ.
The PP remote command determines the paper path, and when this setting
and the paper setting made via the control panel differ, this (paper mismatch)
error occurs.
Recovery
Load the correct paper size, or change the setting in the control panel/driver
to match the size of the paper loaded in the printer. When this error clears,
printing begins.
Table 3-11. Paper Path Command and LED Indicators
PP Command
Roll
Auto Cut
Roll
No Cut
Sheet
Roll Paper Blink Blink Off
Cut Sheets Off Off Blink
Table 3-12. Paper set lever is released (During paper set position)
Item Description
LCD message LOAD PAPER
LED indicator
status
"PAPER OUT" LED goes on.
Explanation The Paper Set Lever is in the release position during paper set operation.
Recovery
Push down the lever after paper setting, the error clears. Then "PRESS
PAUSE BUTTON" will appear and press PAUSE button to start printing.
Table 3-13. Paper jam
Item Description
LCD message PAPER JAM
LED indicator
status
"PAPER OUT" LED blinks.
Explanation
• Paper jam is detected if the both of rear and front paper sensor detects
paper existing.
• Over drive current or mis-synchronization of CR motor is detect.
Recovery
After removing the jammed paper, "TURN PWR OFF AND ON" is
displayed and then reboot by turning off and on.
Table 3-14. Cover open
Item Description
LCD message COVER OPEN
LED indicator
status
N/A
Explanation
The front cover is open.When this error is occurs, the carriage movement
and ink sequence are held. Therefore it may give damages to printing head if
this situation continues very long time.
Recovery
Close the front cover.
• If it occurs during printing, it recover to print ready status
automaticaly.But, the suspended printing pass is never resumed.
Therefore, there may appear a stripe on the print out.
• If it occurs during pause status, it recover to pause status automatically.