Service manual

EPSON Stylus Pro 10000/10000CF Revision B
Operating Principles Printer Mechanism Components 82
2.2.7 Others
COVER SENSOR
The cover sensor switch is attached in cover open and close department, to detect the open
and close condition of the front cover and I/C holder cover where it is attached on the front
side of this machine.
This sensor is doing the operation/halt control of the CR motor and PF motor drive circuit
through the C362DRV board logic circuit after cover condition detection with the sensor.
This control is similar even when the paper hold lever is in cancellation condition.
Figure 2-15. Cover sensor / Panel unit
CIRCUIT BOARD PLACEMENT
There are the panel unit on surface right of this printer, and Power supply circuit board and
C362MAIN board, HJFK board, C362DRV board, circuit board in back compartment of
this printer.
Figure 2-16. Circuit board placement
Front cover detect SW-L
Front cover detect SW-R
IC holder cover SW
Power boardC362DRV board
HJFK board
C362MAIN board