Service manual

EPSON Stylus Pro 10000/10000CF Revision B
Product Description
O
perating Panel 38
1.4 Operating Panel
This section describes the operating panel, the buttons, the lights, and the way you make
settings.
Figure 1-7. Operating Panel
BUTTONS AND FUNCTIONS
Each button on the operating panel and their functions are described below.
Notes:
*1 : 1.27cm/second (5.0cps) paper feed for 2 seconds after the button is pressed. 12.7cm/second
(50.0cps) paper feed if pressed for a further 2 seconds. Maximum feed of 20cm with one
press of the button.
*2 : 1.27cm/second (5.0cps) paper feed for 2 seconds after the button is pressed. 12.7cm/second
(50.0cps) paper feed if pressed for a further 2 seconds.
*3 : Interrupts ink drying and runs the specified operation.LED indicators
Table 1-20. Buttons and Functions
Button
(Second function)
Function
(Normal)
SelecType
Function
Power-On
Function
Power Power on/off N/A N/A
Pause
(Reset)
• Switch -pause/ready
• Reset (press 3 seconds)
N/A
Maintenance
Mode
SelecType
•Printing
Printer status menu
• Except above
Selectype mode
Cutter replace menu
(press for 5 seconds)
Selection of SelecType
menu (major categories)
N/A
Cut/Eject
(Enter)
• Eject sheet*3.
• Cut roll paper (Auto Cut)*3
• Feed roll paper to the
manual cutting position
(cutter OFF)*3.
Confirms and saves
setup values
Paper Feed ↑ Paper feed (reverse)*1 Increase setup value
Paper Feed ↓ Paper feed (forward)*2 Decrease setup value
Paper Source
(Item)
Selects paper source
Selection of SelecType
items (minor categories)
Cleaning
Cleaning Cleans all heads
(press for 3 seconds)
N/A
Paper Source+
Eject+
Paper Feed ↓
N/A
Maintenance
Mode 2
Paper Source+
Eject+
Cleaning
Firmware
reload