Service manual

EPSON Stylus Pro 10000/10000CF Revision A
Maintenance Maintenance inspection items
2
87
o
Is not the piece of paper etc. adhering to the slowing-down gear?
o Is the belt locatedding in the center of the slowing-down gear? (The belt is same
location even if the PF motor is revolved positive revolution or reverse
revolution.)
Figure 6-20.
4.2 PF roller : Confirm the PF roller in the condition which the paper release lever is pulled
in the front (unlock condition).
o Are not the dirt of the ink and paper powder etc. adhering to the PF roller?
o Is there ink dirt in the sub platen?
Figure 6-21.
o
Are not the dirt of the ink and paper powder etc. adhering to the PF driven roller
(Total of 128 pieces : each 4 pieces the installation to 32 holders)?
* Wipe the ink dirt with the cloth that wetted.
* Clean the paper powder with the brush.
o Is not the dirt adhering to 3 support bearings of the PF rollers?
Figure 6-22.
o
Is not the dirt adhering to the PF loop scale?
o Is there the dirt of paper powder etc. in the Paper guide U?
Figure 6-23.
o
Are there the dirt of a cutter damage and paper powder etc. in the ditch periphery
department of the sub platen? (Refer to 4.2.3.2)
CR driven pulley
PF driven roller
PF roller
5. Form conveyance path
Support bearing
Paper guide U