Service manual

EPSON Stylus Pro 10000/10000CF Revision A
Maintenance
G
eneral Maintenance Issues
2
81
*1 : The meaning of the command of the ink remainder quantity and cutter life are as
follows. Refer to 4.2.1.2.
Ink remainder quantity (K) INK LEFT(K)
E*****F
(*1)
The remainder quantity of the
ink is displayed every the ink.
C:Cyan
M:Magenta
LC : Light cyan
LM : Light magenta
Y : Yellow
K: Black
Ink remainder quantity (C) INK LEFT(C)
Ink remainder quantity (M) INK LEFT(M)
Ink remainder quantity (LC) INK LEFT(LC)
Ink remainder quantity (LM) INK LEFT(LM)
Ink remainder quantity (Y) INK LEFT(Y)
Cutter life CUTTER LIFE
E*****F
(*1)
The life of the cutter is
displayed.
Cutter life be about 2000 sheets.
(However in the case of film
system form, about 1000 sheets.)
The life information of the cutter
is reference. Actually, judge
from the piece condition.
Total printing number of sheets TOTAL COUNT
nnnnnnn (Max 6
columns)
Thenumberofsheetsthat
printed it is displayed.
Waste ink counting WASTE INK
E*****F
(*1)
This item is the maintenance
information that the service
engineer uses the maintenance
for the purpose.
[Maintenance call 100] with
the remainder quantity of 3%
[Service call 000100] with
the remainder quantity of 0%
CR motor life monitor CR MOTOR
PF motor life monitor PF MOTOR
Head unit life monitor HEAD UNIT
Cleaning unit life monitor
CLEANING
UNIT
Table 6-3. Status sheet
Item Panel display Setting value Contents
Table 6-4.
Display Remainder quantity of the ink Life of the cutter
E*****F Ink full condition (Full) There is a remainder life (Full)
E**** F
E*** F
E** F
E* F Remainder life is little.
EF End
NN%
Ink remainder quantity is little (The
ink end lamp blinking)
Ink low condition (10% or less of
the remainder quantity)
* The life of the cutter is rough
standard. When the cutter is
exchanged, display becomes full
condition.
0%
Ink end (The ink out indicator
comes on)
C A U T I O N
n Do not carry out the counter initialization withoutnecessary part
exchange/inspection, although the counter initialize is possible
with "the counter initialization menu" of "maintenance mode 2".
(Especially, do not clear the counter of "Waste ink", "Ink
remainder quantity" to the unpreparedness, to exert the
influence on the product actuation.)