Service manual

EPSON Stylus Pro 10000/10000CF Revision B

Adjustment

elf-Diagnostics

5.3.8.4 Cutter

Perform the cutter reliability test.

Perform the cut designated number at designated parameter.

When the reliability number is [-1], reliability is repeated until key is input.

When the reliability number is [-1], the biggest count number is 99,999,999 times (within 8

column), and the count become 0 in the case that this is exceeded.

Following figure showing the cutter reliability test menu sequence.

Enter

Soft Landing 1 : 80%

Soft Landing 2 : 60%

Soft Landing 3 : 40%

Soft Landing 4 : 60%

Soft Landing 5 : 40%

Paper Pre. 100%

Pressure 60%