Service manual

EPSON Stylus Pro 10000/10000CF Revision B
Adjustment
S
elf-Diagnostics
2
51
5.3.4.17 Counter clear
Perform the initialization of the software counter of waste ink counter etc. The
implementation of this item is permitted to only at the time of factory shipment.
Following table showing the list and initial value of the counter that are cleared. Also,
Following figure showing the counter clear menu sequence.
Figure 5-78.
C A U T I O N
n Absolutely do not carry out the counter clear in the field
maintenance.
Reason: If the counter clear is carried out, important
information of the ink consumption counter etc. are changed, so
the normal actuation is not able to warrant after.
Table 5-16.
Counter that is cleared Initial value
Protection counter A 0
Protection counter A work 0
Protection counter D 0
Protection counter D work 0
Ink counter R1 0
Ink counter R2 0
Ink counter R3 0
Sub ink tank counter K 0
Sub ink tank counter C 0
Sub ink tank counter M 0
Sub ink tank counter LC 0
Sub ink tank counter LM 0
Sub ink tank counter Y 0
Ink cartridge counter K 0
Ink cartridge counter C 0
Ink cartridge counter M 0
Ink cartridge counter LC 0
Ink cartridge counter LM 0
Ink cartridge counter Y 0
Total print timer 0
CL flag 0
Initial charge counter 1
Ink type 0
Ink out detection counter 0
Suction correction value 90
Correctable flag H 90
Cartridge change flag 0
CSIC 0
Total ink consumption FFh
Total paper consumption 0
Ink consumption during nozzle check 0
Paper consumption during nozzle check 0
Y ink total injection counter 0
Y ink total injection at previous 0
Y total injection at previous CL2 0
Y total injection at next CL2 0
Table 5-16.
Counter that is cleared Initial value
After the counter clear, display
moves to [Slant check] menu.
Enter
Reset the counter?
Wait a moment.