Service manual

EPSON Stylus Pro 10000/10000CF Revision B

Adjustment Adjustment Steps

5.2.3.12 Cutter Pressure Adjustment

This adjustment is needed in case of C362DRV board replacement, Carriage unit

replacement, Sub platen unit replacement and Shutter unit. If the paper cutter operation will

not be performed correct, you may adjust it.

o Tension Gauge

1. Select the "Check: Adjustment" from the diagnostic mode and push Enter switch, then

release the capping.

2. Select "Adj.: Cutter" and press Enter switch to enter the cutter pressure adjustment.

3. Press Enter switch in several times until "Pressure=35%" will be appeared on the LCD.

4. Move the carriage unit to the center of most right sub platen.

5. Connect the string between cutter and hook of the tension gauge.

Figure 5-15. Cutter Pressure Adjustment

6. When "Exec. Adj.?" will be displayed on the LCD, press Enter switch, the cutter will

be move to downward. At the time, measure the cutter pressure.

7. Pressing Paper feed +/- switches, adjust the pressure to be within 350 and 700gf.

8. Press Enter switch, the cutter move to upward.

9. Move the carriage to the center and most left sub platen, repeat from Step 6 to 8.

Figure 5-16. Adjustment positions

Tension Gauge

Cutter solenoid

String

Paper cutter

Sub platens