Service manual

EPSON Stylus Pro 10000/10000CF Revision B
Adjustment Adjustment Steps
2
04
NOTE: If the lightest pattern judgement is difficult, regard the opposite side of
home position.
10. Enter the "Maintenance mode " and input the value to the "XX1 to XX4".
1. Refer to the Table 5-7/Table 5-8 and confirm the panel input value with used paper
type.
2. Select the panel input group(XX1 to XX$) and display the specified paper panel
input message as shown following figure.
Figure 5-14.
3. Enter the correction address which are shown on the table 5-6/5-7.(Select the
address value by pressing paper feed +/- button.)
4. Press Cleaning button.
5. Enter the value to the Initial value.
6. Press the Enter button.
11. Turn off the printer power.
C A U T I O N
n This adjustment is needed in only Bi-D printing.
n This adjustment is needed for the paper types on following tables
only.


(XX1-XX4)
(correction value)
address
Panel input group
Correction Initial value