Service manual

EPSON Stylus Pro 10000/10000CF Revision B

Adjustment Adjustment Steps

Figure 5-11. VR layout

6. Confirm the value with sheet set is within the ON value (Right value).

EDGE SENSOR

1. Remove the rear cover.

2. Set the adjustment sheet normally. (Refer to Table 5-4, “Test sheet and Adjustable

VR,” on page 201.)

3. Enter the Self-diagnostic mode. (Refer to “Start-up procedure” on page 213.)

4. Select "Test"/"Sensor"/"EdgeAD" by panel operation. (Refer to “Sensor” on

page 217.)

5. Take the carriage and move on the paper manually.

6. Adjusting VR 3 or VR6 (Refer to “VR layout” on page 202.) , the ON-value (Right

value) becomes within the adjustment range. (Refer to Table 5-5, “Adjustment

Range,” on page 202.)

7. Confirm the value with sheet set is within the ON-OFF value (Left value).

Table 5-5. Adjustment Range

Sensor Left (ON-OFF) Right (ON)

P_Front 040 - 04A 040 - 05E

P_Rear 040 - 04A 040 - 05E

P_Edge 0B0 - 0CF 0C0 - 0CF

VR5

VR4

VR2

VR3

VR6

VR1