Service manual

EPSON Stylus Pro 10000/10000CF Revision B

Adjustment Adjustment Steps

5.2.3.9 Offset adjustment for dot missing detector

Automatically determined offset value after the dot missing detection operation. Refer to

the paragraph “Offset adjustment for dot missing detector” on page 201 for details.

5.2.3.10 P_Front/Rear/Edge sensor adjustment

P_FRONT/REAR SENSOR

1. Remove the rear cover.

2. Set the adjustment sheet normally. (Refer to Table 5-4, “Test sheet and Adjustable

VR,” on page 201.)

3. Enter the Self-diagnostic mode. (Refer to “Start-up procedure” on page 213.)

*:Blight Recycle Paper (XEROX) is soled in japanese market only.

4. Select "Test"/"Sensor"/"FrontAD" or "Test"/"Sensor"/"Rear" by panel operation.

(Refer to “Sensor” on page 217.)

5. Adjusting each VR (Refer to “VR layout” on page 202.) corresponding to the each

sensor, the ON-OFF value (Left value) becomes within the adjustment range. (Refer to

Table 5-5, “Adjustment Range,” on page 202.)

C A U T I O N

n Performing these adjustment, set the H top cover and front cover

preventing from outside light exposing.

n Set the paper set lever after adjustment sheet setting.

Table 5-4. Test sheet and Adjustable VR

Sensor Adjustment sheet Rough adjustment Fine adjustment

P_Front

KIMOTO #300

Tracing Paper

VR2 VR5

P_Rear

KIMOTO #300

Tracing Paper

VR1 VR4

P_Edge

Blight Recycle Paper

(XEROX)*

VR3 VR6