Service manual

EPSON Stylus Pro 10000/10000CF Revision B

Adjustment Adjustment Steps

5.2.3.4 Cutter position adjustment

At the power off condition, prepares the A4 size or similar paper and ensure the cut action

carried out normally on the side of a starting point side and opposite side.

Gap between the blade and Sub_Platen should be 0.3 to 0.7 mm.

1. Select the "Test: Sensor" from the diagnostic mode and release the capping.

2. Open the front cover and loosen the all Sub_Platen fixing screws. Then push it to

toward the bottom.

3. At the starting point side, loosen the two of cutter holder screws then mount the L type

adjusting tool on the Sub_Platen. Fix the cutter holder position after the adjustment of

gap to the Sub_Platen.

4. Attaching the adjustment tool from the right side and perform the adjustment with

Sub_Platen fixing screw.(6 Sub_Platens are presented.)

5. Confirm the cutter operation by pressing the cutter cap several times.

6. Shut the front cover and escape from "Test: Sensor" mode. (At this time place the

carriage in the middle of CR rail way.)

7. Turn on the printer power and implement and confirm the paper cut operation.

Figure 5-5.

L Type adjusting tool

C A U T I O N

Do not take the up-and-down motion of the cutter in the place other

than the Sub_planten area.(It will cause cutter blade damage.)