Service manual

EPSON Stylus Pro 10000/10000CF Revision B
Adjustment Adjustment Steps
1
94
5.2.3 Mechanism Adjustment
This section describes the adjustment procedures necessary after replacing certain
parts.Following table showing certain adjustment items.
Do not loosen the screw on the print head department as shown figure 5-1.
C A U T I O N
n Even If the updating processing has discontinued halfway
(because of power off /etc.) with both method, it is recoverable
with same operation again.
n The backup card you use in these steps only works with the
Stylus Pro 10000/10000CF; do not attempt to use it with other
printers.
Table 5-3.
certain parts Adjustment item Required tool Reference
CR Motor CR steal belt tension Tension gauge/1054053 page 195
PF Motor PF timing belt tension Tension gauge/B747700300 page 197
P-Thick sensor
Self diagnostics/ "Paper
Thickness"
page 197
Cutter Sub Platen position Adjustment tool/1070178 page 198
Front cover Cover sensor position page 199
Slide Motor Gear backrush page 199
CR Encoder Encoder position Adjustment tool/1070171 page 200
Print Head Print head slant page 200
Dot missing detector Offset adjustment page 201
Front sensor Paper Detect position page 201
Rear sensor Paper Detect position page 201
P_Edge sensor Paper Detect position Kimoto #300 tracing paper page 201
paper feeding
adjustment
page 203
Cutter pressure Cutter pressure Tension Gauge #F712 page 206