Service manual

EPSON Stylus Pro 10000/10000CF Revision B
Adjustment Adjustment Outline
1
88
5.1 Adjustment Outline
This section describes the adjustment procedures necessary after replacing certain parts and
explains how to perform those adjustment procedures.
5.1.1 Precautions
Before beginning any adjustment procedure, make sure of the following.
5.1.2 Adjustment Tools
The necessary tools for performing adjustment procedures on this printer are shown below.
C A U T I O N
n Before starting any adjustment procedure, find the adjustment
procedure you need to perform in Table 5-2 and verify the order
or the tasks you need to perform.
n When performing an adjustment procedure, double-check the
detailed instructions and caution information for that procedure;
otherwise you may damage the printer.
n When replacing the following, always install a new ink cartridge.
• Ink supply system part: Print head, I/H Assy.,Ink tube, Head
damper
Table 5-1. Adjustment Tools
Name Part Code Notes
Tension Gauge #F712
B747700300/
Standard tool
Max. 4000g
User’s data memory
card
1050073
Standard
PC card acceptable
Type: 2MB Flash memory card
Standard: Type-II (PCMCIA Rel 2.1/JEIDA
Ver. 4.2)
Voltage: 5V Read/Write
Program data memory
card
44 inch roll paper
EPSON special
media
Necessary for mechanism-adjustment
printouts
A3 Tracing paper
Kimoto brand:
MicroTrace
#300LMB
Necessary to determine P_FRONT and
P_REAR sensor volumes
A3 copy paper Standard paper
Necessary to determine P_EDGE sensor
volume
(+)Screw driver(2) Standard tool
Tension Gauge with
attachment
EPSON special tool 300g
Screw lock tight
Filler gauge(0.6mm) Standard tool 0.6 mm
Filler gauge(0.7mm) Standard tool 0.7 mm
Precision screw driver Standard tool
Ink discharge cartridge 1060627 Ink type detection
Cleaning liquid
cartridge
1060626 Print head and tube cleaning
Cutter positioning tool 1070178 Cutter blade position adjustment
CR-ENC setting tool 1070171 CR-RNC position adjustment
Scale insertion tool 1070174 CR_loop scale fixing
Starter Cartridge Lc 1062231 Stylus Pro 10000 (except EAI market)