Service manual

EPSON Stylus Pro 10000/10000CF Revision A
Disassembly & assembly Disassembly Flow
1
86
6. Unlock rear side three latches, then separate the P_THICK sensor to the bracket.
Figure 4-176.
NOTE: Sensor bracket position is adjusted at factory. Therefore, be sure to mark
its current position before removing the screw.
A D J U S T M E N T
R E Q U I R E D
If you move the sensor bracket position, perform the necessary
adjustment listed in “Service Parts & Required Adjustments,”.
Latch
Bracket