Service manual

EPSON Stylus Pro 10000/10000CF Revision A
Disassembly & assembly Disassembly Flow
1
81
4.2.3.21 Removing the Paper Release Sensor
1. Remove the R Side Cover as described in “R Side Cover Removal 124.
2. Remove the Rear Cover as described in “Rear Cover Removal 126.
3. Push the paper hold lever to the rear. (Lock condition)
Figure 4-161.
4. Unlock five latches of the Paper Release Sensor, then remove it.
5. Disconnect connector cable of the Paper Release Sensor.
Figure 4-162.
6. Reference : Paper Release Sensor is connected to CN45 on the C362DRV board.
4.2.3.22 Removing the P_FRONT Sensor ASSY
1. Remove the R Side Cover as described in “R Side Cover Removal 124.
2. Remove the L Side Cover as described in “L Side Cover Removal 124.
3. Remove the Paper Guide L as described in “Paper Guide L Removal 128.
4. Remove the Rear Cover as described in “Rear Cover Removal 126.
5. Remove the Front Cover as described in “Front Cover Removal 130.
6. Disconnect the harness for the Paper_Front Sensor ASSY from the connector CN46 on
the C362DRV board.
7. Remove a screw of the Paper guide L, and remove the Paper_Front Sensor bracket.
Figure 4-163.
Paper hold lever
Paper Release Sensor
Latch
Connector cable
Latch
Screw