Service manual

EPSON Stylus Pro 10000/10000CF Revision A

Disassembly & assembly Disassembly Flow

5. Confirm the fixing location of the motor gear of inside. (Confirm the size of the

backlash with the drive gear.)

Figure 4-153.

6. Remove two screws fixing the PG motor, then remove the PG motor.

Figure 4-154.

7. In the case that remove the drive gear : Remove the E ring with holding down the drive

gear, then remove the drive gear.

Figure 4-155.

Drive gear

Motor gear

Screw

C A U T I O N

When remove the drive gear, pay attention because the drive gear

closes have jumped by the spring, when remove the E ring without

holding down the drive gear.

Ering

Drive gear

Spring