Service manual

EPSON Stylus Pro 10000/10000CF Revision A
Disassembly & assembly Disassembly Flow
1
71
4.2.3.13 Removing Dot Missing Detector
1. Pull out three waste ink tubes from tube clump.
2. Remove the Flushing Box as described in “Removing Dot Missing Detector 171.
3. Lift up the ink pump ASSY to release the carriage lock, and move the carriage away
from the home position.
Figure 4-134.
4. Disconnect the connector connected to CN17, CN18 on the C362DRV board, then
remove it.
Figure 4-135.
W A R N I N G
This unit contains laser generation elements. Be careful handling this
unit. Read precautions given in the preface.
The following label is attached on the unit.
Figure 4-133.
A D J U S T M E N T
R E Q U I R E D
In the case that removed or exchanged the Dot missing detector, carry
out the dot missing offset adjustment.
Window
Dot missing
detector
Cables
(connected to
CN17, CN18 on the
C362DRV board)