Service manual

EPSON Stylus Pro 10000/10000CF Revision A
Disassembly & assembly Disassembly Flow
1
61
4.2.3.7 Removing the Ink Cartridge Holder & Slots
The Ink Cartridge Holder is made up of six individual slots, one for each color of ink. The
following instructions describe how to access and remove one of those slots.
1. Drain the ink as described in the Clean Head section of “Adjustment Menu”.
2. Remove the ink cartridge.
3. Remove the L Side Cover as described in “L Side Cover Removal 124.
4. Remove the I/C Holder Cover as described in “I/C Holder Cover Removal 125.
5. Remove the six flat cables from the CSIC board (refer to “CSIC Board Removal. 137.)
, and then remove the cables from their harness clamps on the ink cartridge holder
sides.
Figure 4-107.
6. Disconnect the air tubes.
Figure 4-108.
7. Put the waste ink paper around the nut. remove the hexagon nuts and remove the nut
ink pipes.
Figure 4-109.
C A U T I O N
n Before removing and ink cartridge slot, drain the ink as described in
the Clean Head section of “Adjustment Menu”.
n To manually perform an initial ink charge, see “Cleaning Menu”.
CSIC Board
Flat cable
Ink Cartridge Holder / Slots
CSIC board
Air tube
Nut
Nut
Ink pipe